(Landcruiser use TC and E1 at DLC1)Ĩ.Once 30 seconds have passed, with the vehicle still in “IG-ON” mode, remove the jumper wire.ĩ.Connect TIS Techstream and begin the registration process. Do not cycle the ignition switch to “OFF” position during this step. Techstream Program TPMS Sensor for Toyota Tacoma 2015Ħ.With the vehicle set to “IG-ON” mode, disconnect the TIS Techstream.ħ.Using Jumper wire or equivalent, connect terminals TC and CG at the D元 connector for at least 30 seconds. ![]() Note:The software download version provide above is the newest version,if you buy the Mini VCI cable from your dealer,them will sent you lower version tested.You would better to run the version provided by your dealer.The newest version is only for DIY’er try,it haven’t been test on all teachstream hardware.Ģ.Turn the ignition switch to the “IG-ON” position.ģ.Select the datalist for the Tire Pressure Monitoring System.Ĥ.Check and set all tire pressures to specification with an accurate tire pressure gauge and compare the information to what is displayed on the datalist.ĥ.After checking the tire pressure, record the TPMS sensors ID numbers.Check below operation case:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |